|
|
|
#1
07-02-2009, 04:01 PM
|
|||
|
|||
sight pusher
Anyone ever made their own sight pusher? I scored a brand new set of nights sight for my Kimber, in a trade (I stole em). Not really but I will say it is one of my best trades ever,got less than 5 bucks in them.
I have read something about using a drill press with a wooden dowel or a brass punch as a bit. Not turning it on, just as leverage tool with a vise. Any thoughts?  
|
|
#2
07-02-2009, 04:06 PM
|
||||
|
||||
|
Good luck. Kimber sights are TIGHT.
__________________
-Kimber Pro Carry HD by Chuck Rogers -Kimber Combat Carry -Ruger MkII .22 Target -S&W M&P .38 Special
|
|
#3
07-02-2009, 04:08 PM
|
||||
|
||||
|
__________________
The Republic of Texas – Not just a state but an attitude! Liberals are like Slinky's - not good for anything but will bring a smile to your face when pushed down a flight of stairs  All you DFW TGT members watch the HOME TOWN section for up coming events and meets! "Ding" another post!
|
|
#4
07-02-2009, 09:09 PM
|
|||
|
|||
|
I saw that link but I am not sure how it works when you get the two alum. block tight against the slide. How would there be any clearance to put the sights in to get them started? On the other hand how would you push the old ones out?
|
|
#5
07-02-2009, 10:44 PM
|
||||
|
||||
|
Well, if you were in NB, you could borrow mine. Or you can git yer own from Nicholson - Nicholson Performance - Home
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
