So, I'm in the process of fixing the A/C in the Honda, and one of the screws I have to remove to get the resistor module off of the blower motor is almost impossible to get at. Went to the hardware store to look for one of those Phillips drivers bent 90 degrees, but found this instead:
It's magnetic with a hex drive on one side, a 1/4" square drive on the other, and enough grip that you can apply quite a bit of torque to get something loose.
Here's the actual size, and even as small as this is there still almost wasn't enough room to get that dang screw out.
It's magnetic with a hex drive on one side, a 1/4" square drive on the other, and enough grip that you can apply quite a bit of torque to get something loose.
Here's the actual size, and even as small as this is there still almost wasn't enough room to get that dang screw out.