Attn: Tac65 owners

[TKG]

I was wondering if somone can do me a small favor. My can should be coming in VERY soon. I really don't want to pay $50 for the endcap driver tools and wanted to build my own. I need a couple measurements off the can or tool itself. I tried calling Tactical Innovations, but they're weren't any help. Could someone measure the the hole size on the endcap or the bar size on the tool and the width that the posts are across? Any help would be really appreciated. I read where it helps to put anti-seize on the endcaps before using the can and I want to be ready to go. Thanks guys.


- Steve

 

[LJH]

Dont waist your time making it just for the tac 65. Do this instead that way you can use it on any thing. Its faster and cheaper too.

 

[shooterfpga]

Dont waist your time making it just for the tac 65. Do this instead that way you can use it on any thing. Its faster and cheaper too.

+1 seen this method used for a variety of gunsmithing.

 

[TKG]

Have you tried this on a Tac 65? If so, any chance you know the diameter of the studs.