barrel decisions

[TEXAS "All or nothing"]

I have factory barrels, ported and threaded. Threaded gives the option to remove device and ported leaves you stuck with it. I have a P226 in 357sig I've been thinking about buying a barrel from bar-sto in either 3 port or threaded. While the holster wouldn't matter on which barrel is in it at the time (works with all), I'm wondering what would you do? Ported leaves it slimer, but could find a brake that doesn't take up much room?

 

[ZX9RCAM]

Does the ported barrel extend past the slide, or would you have the slide cut?

 

[baboon]

I recently bought a factory thread barrel for my Sig 226 9mm. I'm having a new booster made for an old can that I sold the gun. Ported barrels are not something I'm into.

 

[TEXAS "All or nothing"]

Does the ported barrel extend past the slide, or would you have the slide cut?

I won't cut the slide, so it'll stick past about an inch or less on ported barrels.

 

[ZX9RCAM]

I won't cut the slide, so it'll stick past about an inch or less on ported barrels.

Then evidently your holster has an open end/bottom?

 

[TEXAS "All or nothing"]

Then evidently your holster has an open end/bottom?

It is

 

[oldag]

Personally, I don't see the need for ports on a .357 Sig.

 

[TEXAS "All or nothing"]

Personally, I don't see the need for ports on a .357 Sig.

Do you have a suppressor.........................I don't see a need for those either

 

[zackmars]

Neither.