Bolt-on Kydex cheek riser

[acorneau]

++1 on this...just got one yesterday and will install on SavFCP today.

Let us know how the installation goes and how you like it (or not).

 

[acorneau]

++1 on this...just got one yesterday and will install on SavFCP today.

So, impressions so far?

Inquiring minds want to know!

 

[Leper]

Because of this thread, I bought the tactical works one. Took me longer to get my tools together than it took to do the install. I got the blemished version to save some coin. Couldn't find the blemish. It is simple and effective. Put a few rounds through it on my .308. I like it.

 

[KiloKilo]

So, impressions so far?

Inquiring minds want to know!

Well, finally got this done. Sorry for taking so long.........simple install, took about 30 minutes, works great.
KK

 

[Leper]

Nice harbor freight woodworking bench you have there. At last I'm not the only one.

 

[acorneau]

I just got mine in the mail today and will be fitting it this weekend.

Did a "dry fit" over the 10/22 stock and it sure seems big (width wise) compared to the standard stock. I hope it clamps down well enough to maintain it's positioning.

 

[Dawico]

I just got mine in the mail today and will be fitting it this weekend.

Did a "dry fit" over the 10/22 stock and it sure seems big (width wise) compared to the standard stock. I hope it clamps down well enough to maintain it's positioning.

It shouldn't be a problem. They bolt down very solid.

 

[Leper]

Tactical works has a demo on how to reshape it, that is if yours is kydex.

 

[40Arpent]

I went with Tac Pro, as they have a narrower version for slimmer stocks, and a contoured side that gives an improved cheek-to-riser fit. I also got their wider version for my M1A.

 

[KiloKilo]

Nice harbor freight woodworking bench you have there. At last I'm not the only one.

LOL........yeah, the HF bench has been pretty handy. I just wish the drawers were a little deeper and would slide out a little further. HF has some "good stuff" as well as "junk"......ha,ha!
KK