Resizing 40,357sig

[country_boy]

I’m tying out my 40sw and 357 sig dies today. When I resize I’m left with an 1/8 that’s not being resized. Can I first run the brass through my Lee bulge buster????
My hand guns are sig p series they aren’t glocks.

 

[deemus]

I would run 5 all the way through the processes. See if they feed properly.


If there’s a problem you only have 5 to pull the bullets on.

 

[country_boy]

That’s what I normally do. I mentioned not having a glock because of the big warning thats printed on the instructions.

 

[Dred]

I’m tying out my 40sw and 357 sig dies today. Can I first run the brass through my Lee bulge buster????

Absolutely. The 10mm/40 bulge buster will get you sized to the base of .357 Sig, 40 or 10. It's a pass through. This is what the bulge buster is designed for.

Note: I don't play at the upper pressure limit with bulge busted brass. I would advise you to be conservative with brass you're wprking this hard.

Sent from my KFMAWI using Tapatalk