Part of my gun goals for 2017 is to catch up on my bulk plinking ammo loading.
A few months back I got serious and loaded about 4000 rounds in a few weeks. The factory ball handles wore my palm out.
Under normal loading conditions the ball handles aren't an issue but since that extended session I have been looking for a fix. I get these ideas in my head and sometimes it takes a while for me to solve any pending issues before I start the project. This project was just like that.
I know there are commercial units available but I am very much a DIYer and a self admitted cheap skate. If I can do it myself I almost always go that route. I really like to tackle an issue on my own and make things I already have work.
Like most of my write ups I will break this into multiple posts. It makes it easier to quote a smaller section for specific questions.
A few months back I got serious and loaded about 4000 rounds in a few weeks. The factory ball handles wore my palm out.
Under normal loading conditions the ball handles aren't an issue but since that extended session I have been looking for a fix. I get these ideas in my head and sometimes it takes a while for me to solve any pending issues before I start the project. This project was just like that.
I know there are commercial units available but I am very much a DIYer and a self admitted cheap skate. If I can do it myself I almost always go that route. I really like to tackle an issue on my own and make things I already have work.
Like most of my write ups I will break this into multiple posts. It makes it easier to quote a smaller section for specific questions.