folks i need some info here. Just picked up an AT84S yesterday. before i picked it up i found out that it was a very high quality cz75 clone - pre CZ75B. Fit and finish is excellent, no rattle and just an overall great finished handgun. It is a little beat up with dings in certain places. Didn't cost me too much to get it except for a long drive.
Now after i cleaned it up, i did more research on it and found out that tanfoglio supplied some if the parts to the Swiss factory. Now here is where it gets interesting. Some people commented that there are some earlier versions that had weak steel, especially in the slide.
So i got a few questions here:
1. My serial number is 0277X - I don't know how many were produced. i think i read the weak slide happening on the first 1000 serial number.
2. What mags will fit in this gun.
3. Apparently there is an earlier version of this called the AT84 - without the S marking after the 84. what is the significant difference between the 2?
4. Will tanfoglio/ eaa witness internals fit (trigger bar, hammer, etc) ?
thanks ! loving it so far. need to take it to the range soon. pics will be up shortly
Now after i cleaned it up, i did more research on it and found out that tanfoglio supplied some if the parts to the Swiss factory. Now here is where it gets interesting. Some people commented that there are some earlier versions that had weak steel, especially in the slide.
So i got a few questions here:
1. My serial number is 0277X - I don't know how many were produced. i think i read the weak slide happening on the first 1000 serial number.
2. What mags will fit in this gun.
3. Apparently there is an earlier version of this called the AT84 - without the S marking after the 84. what is the significant difference between the 2?
4. Will tanfoglio/ eaa witness internals fit (trigger bar, hammer, etc) ?
thanks ! loving it so far. need to take it to the range soon. pics will be up shortly