threaded my .30cal can onto my new barrel to check it out and I ran a (Dewey)cleaning rod through and it was off center but it had a little wiggle room so it may have been the rod has a slight bend. I spin the rod and it mostly stays somewhere between 1/32-1/16(I'd guess) off center. One time I check it seems ok check again not so much haha.
Any other ways to check without it being costly? I'd hate to ruin a $800 can with a test shot.
I've looked down the bore but same story once it seems ok, the next I'm not sure. Guess I'm over thinking it
Any other ways to check without it being costly? I'd hate to ruin a $800 can with a test shot.
I've looked down the bore but same story once it seems ok, the next I'm not sure. Guess I'm over thinking it
Last edited: