Suggestion for a better option? I have contemplated one of these as well (like will get one just to go with the mags I already have) but would love to hear about other options.Been there done it. Buy something else.
Ruger pc9. It’s problems are insignificant. Or manageable would be a better word.Suggestion for a better option? I have contemplated one of these as well (like will get one just to go with the mags I already have) but would love to hear about other options.
You’re collar for the recoil tube and frame will need attention right out of the box. Keltec does three things from the factory: they jerk off on it and hopes it sticks. They forgot to put anything on. Or they put the keltec recommended tiny droplets of thread locker that don’t hold anything over a couple hundred rounds.Well, I ordered one. I'll let you know if I love it or hate it.
I ordered it from Hesters Gun Shop website here in the Palestine area. I've heard good things about them.
I don't think I'll regret it.
I'm sure another PCC will follow shortly. That Stribog.. hmmmm
MCARBO will get you the bits to make it a solid and consistent shooter.Well, I ordered one. I'll let you know if I love it or hate it.
I ordered it from Hesters Gun Shop website here in the Palestine area. I've heard good things about them.
I don't think I'll regret it.
I'm sure another PCC will follow shortly. That Stribog.. hmmmm
Glad I'm not a lefty then. I can see the design problem for a left hander.I wanted to love my Sub 2000. It functioned fine and was accurate, but I never have been gassed in the face by anything as bad as that Sub2k. I'm left handed and that thing would blow burning powder directly back in my face. Even with eye pro it was still uncomfortable for me. Had to move it along down the line. Can't imagine how much gas would come out of the charging port running a suppressor.
Good advice. I HATE soft hardware. Few things peeve me more than a quality piece with a stripped screw head. I'll replace them immediate.You’re collar for the recoil tube and frame will need attention right out of the box. Keltec does three things from the factory: they jerk off on it and hopes it sticks. They forgot to put anything on. Or they put the keltec recommended tiny droplets of thread locker that don’t hold anything over a couple hundred rounds.
If the the frame screws need to be tightened be very careful. They are aluminum and very soft. I wouldn’t put much inch lbs on em.
If you decide to and I recommend so, install a stronger adhesive between the collar and frame. I’m of the opinion it’s what will help quiet things down when running a can.
There are aftermarket feed ramps for it and frame pins.
For the first few hundred rounds I say oil the shit out of the rear part of the two piece bolt and where the charging handle is. Things will try and peen there.
Keltec has good ideas but they can’t manufacture guns correctly.Good advice. I HATE soft hardware. Few things peeve me more than a quality piece with a stripped screw head. I'll replace them immediate.
After I clean the Kel-tec jizz off that is.