but have dealt with junk screws.
I see what you did there.I never had junk screws, just some that are better than others....
I never had junk screws, just some that are better than others....
Even better....Drunk screws?
And some left-handed drill bits in assorted sizes.Get yourself a good screw backout kit. They can save you a lotta grief.
I didn't have any issues with mine. I just picked one up with the Vortex Viper. I had to take off the installed rear mounting plate and stick the Vortex plate on. All threaded holes were helicoiled! Pistol came with a spare set of plate mounting screws too.Would it be prudent to get new, non-oem, screws before fitting a mrds to a tp9sfx?
View attachment 185376 View attachment 185377 View attachment 185378 View attachment 185379 View attachment 185380 i’ve got a 1/16 allen screw that won’t come out. holds the bolt release. i haven’t completely stripped it out but i’ve tried 1/2 dozen times heating up the wrench red hot and blow dryer to the receiver where screw sits. blue loctite. i can’t get straight on with this 3/8 drive i bought. the little allen wrench with a cheater for leverage wouldn’t budge it. i think the 3/8 with a ratchet should get it done but not at a slight angle.
even if it came to removal with extractor i couldn’t get straight at it. i don’t want to put real heat from a torch to the receiver because i spent too much cash prepping & painting. i just can’t do it