What are those black racks you have up against the wall holding all the yellow bins??Accessories are IMHO user specific.
Depending on bench height and loading preference (standing or sitting) you may want a Strong Mount riser (or fabricate your own to height desired).
My must have list:
Case Feeder- Can't imagine a progressive without it (with small/large rifle and pistol plates as needed).
Roller handle- You'll be glad you did if you do any volume at all.
Primer downtube conversion- I think that was the very first thing I changed (that little tray sucked).
Lighting- KMS is by far the best and brightest I have found.
Spare Parts Kit- One is a must, two is better (you will need it)
Powder Alarm- You will want this (get it you will be glad you did).
Primer Alarm- Can't remember if this comes with the machine or not (if not, get it)
Optional:
Quick Change setup-Makes caliber changes so easy and quick.
Bullet Feeder-If doing any volume loading, these rock (with caliber conversions for Quick change setup).
Trimmer and trim dies-Quick and accurate case trimming for volume batches.
Other:
Large/Tall Powder Hopper- Just makes life a little easier (especially in rifle caliber)
PrimaFill- If loading tubes in volume this takes the dread out it (if you have your tubes laid out and primers out of the box and staged you can fill 10 tubes in well less than five minutes).
Canned Air- Trust me on this one.
There will be lots of little mods you will find to try but are for the most part relatively inexpensive.
Using a progressive is a different animal and takes some getting used to.
A lot happening with every pull of the handle.
Setup is everything-if you are fighting it, something is not right-another thread for that one.
My setup:
View attachment 408492 View attachment 408493