Greetings All! new to the forum and not certain if this is the place for this post/question but had to start somewhere.
I am restoring a 1943 Willys Jeep, as the final part of that project I purchased a browning 1919 parts kit and plan on converting this to a semi-auto. It is an Izzy gun and I have acquired a blank RH side plate to machine. My question is, does anyone have the drawings for machining this? It would be ideal if the drawings were in CAD as I could easily feed these into my mill and save myself a lot of time doing this by hand. I have purchased a set of drawings but, in all honesty, they are somewhat lacking in details that I am used to seeing on machining drawings. I can probably use them but it will be slow and I will have to stop at every step to question the actual, original intent of the draftsman. Any thoughts or advice will be appreciated.
J
I am restoring a 1943 Willys Jeep, as the final part of that project I purchased a browning 1919 parts kit and plan on converting this to a semi-auto. It is an Izzy gun and I have acquired a blank RH side plate to machine. My question is, does anyone have the drawings for machining this? It would be ideal if the drawings were in CAD as I could easily feed these into my mill and save myself a lot of time doing this by hand. I have purchased a set of drawings but, in all honesty, they are somewhat lacking in details that I am used to seeing on machining drawings. I can probably use them but it will be slow and I will have to stop at every step to question the actual, original intent of the draftsman. Any thoughts or advice will be appreciated.
J