RandomHero
Well-Known
just gonna post this here for any car guys that may be interested.
Located in San Antonio, near Sea World
CAR DOES NOT RUN, IS IN ROLLING STATUS.
ASKING: $1000, semi-firm
Here we go.
91 2.2 chassis
3VZ swapped
AP1 (s2000) rims
Needs:
Spark Plug Wires
Battery
Motor mount on the tranny drilled and tapped
????
background:
i bought the car already swapped. i drove the car and enjoyed the hell out of it, even though it was middle of summer and it didnt have AC nor did the passanger window roll down. The previous owner half assed the swap and i ended up breaking a motor mount. SInce then the car hasnt ran. i pulled the motor to fix the motor mount issue and adress other problems.
As far as i know, this car will run if someone verifies the wiring was done right, checks the grounds, gets a new battery and spark plug wires for it. Also, you might want to hand crank the motor to make sure it isnt seized, although i dont see why it would be as it isnt open to the elements. Also, needs the motor mount on the transmission mount and taped for an M10 bolt which i have the bit for and will include.
old pix:
current pix
i do have the front bumper and carpets for the interior.
Located in San Antonio, near Sea World
CAR DOES NOT RUN, IS IN ROLLING STATUS.
ASKING: $1000, semi-firm
Here we go.
91 2.2 chassis
3VZ swapped
AP1 (s2000) rims
Needs:
Spark Plug Wires
Battery
Motor mount on the tranny drilled and tapped
????
background:
i bought the car already swapped. i drove the car and enjoyed the hell out of it, even though it was middle of summer and it didnt have AC nor did the passanger window roll down. The previous owner half assed the swap and i ended up breaking a motor mount. SInce then the car hasnt ran. i pulled the motor to fix the motor mount issue and adress other problems.
As far as i know, this car will run if someone verifies the wiring was done right, checks the grounds, gets a new battery and spark plug wires for it. Also, you might want to hand crank the motor to make sure it isnt seized, although i dont see why it would be as it isnt open to the elements. Also, needs the motor mount on the transmission mount and taped for an M10 bolt which i have the bit for and will include.
old pix:
current pix
i do have the front bumper and carpets for the interior.