Over the years it's become one of my favorite powders for gas guns. I mostly load 60gr and up with it for a few rifles, all with satisfactory results. I've never popped a primer and keep reading about how it tightens up near the top end. My current plinking load is 24.4gr under a Hornady 62gr btsp wc bullet ignited by wolf or cci srm primers. I've pushed this load only up to 25. I'm using sierras older service rifle data which shows their 63gr SP loaded up to 25.5.
At 24.5, 24.8 it didn't look much better than 24.4 but if there's a better node near 25.3-25.5 I'm curious to know if anyone here has found it. I'll most likely just batch out 10 ea at 24.9 and 25.2 that's s kinda where I left off anyhow. Still always nice to hear from someone who's been there and done that. Thanks for any contribution gentlemen.
At 24.5, 24.8 it didn't look much better than 24.4 but if there's a better node near 25.3-25.5 I'm curious to know if anyone here has found it. I'll most likely just batch out 10 ea at 24.9 and 25.2 that's s kinda where I left off anyhow. Still always nice to hear from someone who's been there and done that. Thanks for any contribution gentlemen.