It’s the OMEGA so it has the factory night si and rail. Comes with the carrying case, and the two mags!
My wife put one magazine through it before deciding it was too big for her hands, however it’d be just fine for an average size person.
Asking $600.00, paid $650.00 for it a week ago...
I purchased this gun beginning of August and have less than 100 rounds through it. It's a fantastic pistol but my fiance decided she wants a commander length instead.
I paid $920 ($849 + tax). Asking $800
I can meet anywhere in or around the San Antonio area.
This gun has been upgraded with many parts from Cajun Gun Works (CGW) and converted to single action only. It is a fantastic range gun and the trigger is superb. It has been well cared for and I have experienced zero malfunctions.
List of mods:
CZ Custom Aluminum Thin Grips
CGW Full steel...
If you're looking for a non-compromise firearm that can accommodate a red dot - WITHOUT breaking the bank, look no further.
The IWI Masada is an Israeli firearm so it's been battle tested. It got a 17+1 capacity, and sized similarly to the Glock G19x. If you're not familiar with it...
Spikes Tactical stripped lower receivers, these were never assembled, pistol or rifle configuration, low shelf, multi cal, serial numbered to box. They are from a private collection so there's no forms to fill out, just be over 21 years of age & show a current Texas drivers license. $ 225.00...
∆Smith & Wesson® M&P Shield, Performance Center
•Ported barrel and slide, from factory
•Lighter trigger pull from S&W Performance Center
•Night sights, factory
•Two factory magazines included
•Like new condition, less than 100 rounds fired
•Great for concealed carry
Starting to look for a good used pistol. What is the norm and what should I run away from when I hear it? Looking at 9mm Sigs & CZ based on what I've been reading. Throwing this out there and I'll be back later today. Thanks in advance
Posting for interest. Available for sale is this HK USP Expert in 9mm. V1 trigger (SA/DA), manual safety.
I am the first owner, shot approximately 400 rounds through it. Still in excellent condition. I installed Talon grips, they are easily removed. Comes with four 15 round mags, factory...
Up for sale/trade is a clean little 1911. I'm not going to list all the specs, but if you don't know what it is you've been living under a rock lol.
Smooth shooting and very reliable. I've run 124gr Speer Gold Dot down to 115gr "light" loads with very little recoil.
Easy to carry and...
Looking to fund another Italian pistol, so selling this one. This is a mid-90's production Beretta 92fs. This is one of the very first pistols I bought and it was well taken care of. The only visible ding is a scratch on the finish around the dovetail when the Novak rear sight was installed...
Parts needed for pistol build. I have a AR 9mm block type lower and a side charging upper. Just need part to complete the build.
AR-15 9MM barrel, 7 to 9"
Hand-guard/rail prefer M-Lok. No quad rails. 7"
BCG for 9mm AR, needs to work with glock mags
Lower parts, want something like Strike...
I have a clean gen 4 19 for sale. Here's what it comes with.
-Streamlight TLR-1 $130-$150
-AmeriGlo sight set. Red circle front Trijicon rear night sights.
-Eight 15 round Glock mags. They come with three from the factory. 5 extra at $20 each.
-Bench Master mag holder. Holds up...
I need a small pocket pistol. I am not interested in 380. I would like 45. But that is a lot of caliber in such small gun. So I'll go with a 9mm if I can find one in a pocket pistol.
Looked at Ruger LC9. It is too big for a pocket pistol. Any suggestions on a pocket 9MM.
Please don't waste...
Having had only revolvers for home SD I recently applied for my LTC (oh the waiting game). I picked up a Ruger LCP to carry but wanted to consider a 9MM as another option. Browsing Bud's Gun Shop I stumbled across a Taurus PT111 Millenium G2 for $210. I haven't given the brand or the gun much...
Don't hold the PA address against me. I have friends all over Texas that I developed through years of having Texas as part of my Region in Sales. Mostly sold to hydraulic and pneumatic distributors that then sold into high tech mfg plants like Dell and Intel. Friends in Houston, DFW, Austin...
At the SHOT Show I got to see the Boberg gun in person for the first time. I've never read an article about it that didn't reference it's cycling flaw with certain ammo, and even more concerning, the guy at the Bond Arms booth (Bond bought Boberg recently) said they have no plans on fixing the...
Howdy! I'm a relative newby that lives near Tyler. Interested in keeping up with self-defense pistols and hunting rifles. Also have a gripe I'll share in a couple of days. Looking forward to participating.