I have been working on changing my bullet of choice from X-Treme plated to Acme coated. The are a bit cheaper and so far have shown accuracy the same or better than the plated/FMJ bullets I have used in the past. There is only one issue that seems like a negative, still the "smell" of polymer (accepted is not a factor) and "smoke" when fired. As compared to "lead" the smoke is in the range of only 10% as bad.
I am using 124 g Acme coated with 4.2g TiteGroup. I have found some recommendations that state that TG burns too hot for coated bullets.
CFE 5.0 g seems to be a bit better, but would like to hear what others have used with success.
PS G-T-G (Good to Go) remanufactured ammo seem to have solved the issue, but have not been able to pry out the load data they use.
I am using 124 g Acme coated with 4.2g TiteGroup. I have found some recommendations that state that TG burns too hot for coated bullets.
CFE 5.0 g seems to be a bit better, but would like to hear what others have used with success.
PS G-T-G (Good to Go) remanufactured ammo seem to have solved the issue, but have not been able to pry out the load data they use.