You won't see those at 3000fpsThe pulled bullets. A few have some marks but nothing I am concerned about. Barrel rifling will fix that. View attachment 190125
Sent from my LM-G820 using Tapatalk
You won't see those at 3000fpsThe pulled bullets. A few have some marks but nothing I am concerned about. Barrel rifling will fix that. View attachment 190125
I just glued a magnet on each side of the factory catcher to hold it in place.I won a 3d printed primer catcher for my RC II press on a free FB drawing.
The original spent primer catcher was a joke and this little kit so far has caught 100% of the spent primers and anvils.
The only catch is you have to spin the ram around so if you prime on the press it won't work.
It sets up very easily and really makes a world of difference. If I had bought it I would consider it ~$20 well spent.
Www.loadertools.com is their site and they make a handful of handy pieces to compliment your reloading equipment. View attachment 190461
I didn't have an issue with it moving. Besides not liking all the junk on the frame from the primers hitting there they work around the front and fall on the floor sometimes.I just glued a magnet on each side of the factory catcher to hold it in place.
View attachment 190465
True. Lehigh makes an extreme penetrator and extreme defense. I am loading the extreme defense. Lots of youtube vids on this stuff but who knows for sure. There is a limit that one can get with .32 acp but I believe that this cartridge would be more potent than a fmj Fiocchi and is a mouse gun no matter what. For times I pocket carry and hope to never have to test it. Perhaps it is advertising hype. In any event it functions well in a Kel-Tec P32.It's not about how deep it goes, it's about what it does inside you
Sent from my LM-G820 using Tapatalk
I did 4 groups with 4 loads and they were all pretty much like this one. I did like this group because it's mostly spread on the horizontal and that was probably just me shooting. There was another group that was just slightly more compact than this and looking at the chronograph it was a little.more consistent. It was 41.7gr h100v behind an 87gr bthp seated to fit the chamber. The chrono was 2996-3026 with a SD of 11.0. The group shown was 42.6gr and was closer to 3110 avg and 30.6 SD.One of those coins could have given you a nice 3 shot group.
The load data says I can get 3400 out of them but I don't really see the point.