these wad cutters are 148 grain flat.
I ran a batch of them with 4.5 gr of Unique and leaded up my gun.
I see where I must have pushed them too fast, which is more than likely the cause of the leading.
that lead is such a booger to get out, I just didn't want to worry about that in the future
There are several manufacturers who make lead removers both for the barrel and forcing cone. The "Lewis Lead Remover" is but one. I'd post a link but TGT's goofy software doesn't allow me to cut and paste anything....it also ignores about every 10th keystroke.these wad cutters are 148 grain flat.
I ran a batch of them with 4.5 gr of Unique and leaded up my gun.
I see where I must have pushed them too fast, which is more than likely the cause of the leading.
that lead is such a booger to get out, I just didn't want to worry about that in the future
these wad cutters are 148 grain flat.
I ran a batch of them with 4.5 gr of Unique and leaded up my gun.
I see where I must have pushed them too fast, which is more than likely the cause of the leading.
that lead is such a booger to get out, I just didn't want to worry about that in the future
TThe "Lewis Lead Remover" is but one. I'd post a link but TGT's goofy software doesn't allow me to cut and paste anything....it also ignores about every 10th keystroke.
No, I can cut and paste to my heart's content on every website except TGT. TGT also ignores many of my keystrokes and won't allow new paragraphs.Funny I have zero problems cutting and pasting links. Me thinks it's not TGT's fault.
LEWIS LEAD REMOVER | Brownells
Missouri Bullet Company
ive had non stop leadding issues with my .40's no matter what lube i used. i switched to PC and no more issues. it takes about the same time to do as lube and sizing.
these wad cutters are 148 grain flat.
I ran a batch of them with 4.5 gr of Unique and leaded up my gun.
I see where I must have pushed them too fast, which is more than likely the cause of the leading.
that lead is such a booger to get out, I just didn't want to worry about that in the future
I'm guessing revolver. .38 spl or .357mag?
yeah, I loaded them up in 38 special
That's a fairly heavy charge for .38.
Drop it down to 4.0 and see how that goes. Should have a 900fps velocity, give or take.
Have you measured the diameter of the wadcutters?